2 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70

  • Model:DF-70-2

£68.64

2 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70

2 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70.

All the parts are contained in this kit to raise a Daihatsu Fourtrak body by a nominal 2 inch
Including a 2" universal transfer lever

Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 2 inch kit is the easiest of our kits to fit needing only the modification or removal of the fan cowling on the radiator - further instructions can be found Here and you'll find some FAQs Here.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

  • Polystone™ Grade 500, high density polyethylene
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • UV Resistance: Poor
  • Translucent
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.
The transfer lever can either have a 10mm x 1.25 pitch thread or a 8mm x 1.25 thread, please check before ordering

This kit will fit:

Diahatsu F70
Diahatsu Rugger
Diahatsu Rocky
Diahatsu Fourtrack
Diahatsu Foroza
Years:
1984 - 2002

Do you supply nuts with this kit?

No, all the nuts on the Fourtrac range are captivated, on the front and rear within the wings and are inaccessable, and on the centre 6 mounts the nuts are part of the large washers on the bottom of the mounts. We supply bolts with the correct thread to fit these captivated nuts complete with washers and spring washers to prevent the bolts from undoing.