3 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70.
All the parts are contained in this kit to raise a Daihatsu Fourtrak body by a nominal 3 inch
If you require a transfer lever extension to go with this lift please check the size of the thread on you transfer lever, it can either be 10mm (same size diameter as your bolts) or a 8mm
Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.
The 3 inch kit may need extra modification but usually not anything serious - further instructions can be found Here and you'll find some FAQs Here.
We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)
- Polystone™ Grade 500, high density polyethylene
- Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
- Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
- Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
- Maximum Temperature: 248°F 120°C
- Minimum Temperature: -148°F -100°C
- Autoclavable: No
- Melting Point: 266°F 130°C
- Tensile Strength: 4550 psi (31.37 N/mm2)
- Hardness: SD65
- UV Resistance: Poor
- Specific Gravity: 0.95
Bolts & Nuts
8.8 high tensile steel bolts
All Bolts 50Nm
Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.
The transfer lever can either have a 10mm x 1.25 pitch thread or a 8mm x 1.25 thread, please check before ordering
This kit will fit:
1984 - 2002