2 inch Body Lift Kit - Challlenger/Sport/Nativa/Dakar
2 inch Body Lift Kit - Challlenger/Sport/Nativa/Dakar.
This kit contains the spacers and bolts to raise your truck's body by a nominal 2 inch
Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.
The 2 inch kit is the easiest of our kits to fit needing only the modification or removal of the fan cowling on the radiator - further instructions can be found Here and you'll find some FAQs Here.
We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)
- Polystoneâ„¢ Grade 500, high density polyethylene
- Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
- Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
- Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
- Maximum Temperature: 248Â°F 120Â°C
- Minimum Temperature: -148Â°F -100Â°C
- Autoclavable: No
- Melting Point: 266Â°F 130Â°C
- Tensile Strength: 4550 psi (31.37 N/mm2)
- Hardness: SD65
- UV Resistance: Poor
- Specific Gravity: 0.95
Bolts & Nuts
8.8 high tensile steel bolts
All Bolts 50Nm
Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.
You may need to enlarge the hole below the central console behind the gear lever and transfer lever to allow the lever to stay in gear.
This kit will fit:
Mitsubishi Pajero Sport
Mitsubishi Montero Sport
Mitsubishi Shogun Sport
1996 - 2008
1997 - 2010 (Middle East)