4 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70.

  • Model:DF-70-4

£110.74

4 inch Body Lift Kit - Daihatsu Fourtrak/Rocky/Rugger/F70.

Contained in this kit will be:

  • Set of 10 spacers with bolts, washers and spring washers
  • Set of Steering Spacers
  • 3" Universal Transfer Lever

Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 4 inch kit may need extra modification but usually not anything serious

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

  • Polystone™ Grade 500, high density polyethylene
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • UV Resistance: Poor
  • Translucent
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.
The transfer lever can either have a 10mm x 1.25 pitch thread or a 8mm x 1.25 thread, please check before ordering

Do you supply nuts with this kit?

No, all the nuts on the Fourtrac range are captivated, on the front and rear within the wings and are inaccessable, and on the centre 6 mounts the nuts are part of the large washers on the bottom of the mounts. We supply bolts with the correct thread to fit these captivated nuts complete with washers and spring washers to prevent the bolts from undoing.