1 inch Body Lift - Trooper/Bighorn/Monterey/Jackaroo SWB

  • Model:IZT-SWB-1

£76.15

1 inch Body Lift Kit - 3 Door SWB Model.

This kit is for the Isuzu Trooper and Bighorn, Opel/Vauxhall Monterey and the Holden Jackaroo and contains all the parts to raise your truck's body by a nominal 1 inch

Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 1 inch kit is the easiest of our kits to fit needing only the modification or removal of the fan cowling on the radiator - further instructions can be found Here and you'll find some FAQs Here.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

  • Polystone™ Grade 500, high density polyethylene
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 56Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting, the existing front 6 bolts are fitted down through, the rear ones are fitted up through into captivated nuts (we supply the correct bolt for the captivated nuts) - you may have to replace some of the front 6 up through.
Bumpers are raised by drilling new holes in the bumper brackets 1 inch below the original top one and (on the front only) drilling a hole 1 inch above the original lower hole in the chassis (you will need a new nut for this hole.

FAQs

Please check out our FAQs Here

Vehicle Specific FAQs: