2 inch Body Lift - Terrano2/Mistral - SWB

  • Model:NT2-SWB-2

143.03€

2 inch Body Lift Kit - Terrano2/Mistral/Ford Maverick SWB.

This kit is for the short wheel base Nissan Mistral also known as the Nissan Terrano 2 and will also fit the Ford Maverick it contains all the parts to raise your truck's body by a nominal 2 inch

Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 2 inch kit is the easiest of our kits to fit needing only the modification or removal of the fan cowling on the radiator - further instructions can be found Here and you'll find some FAQs Here.

We can also make a 3 inch and 4 inch kit for these vehicles but these would need additional spacers on the steering linkage

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Scroll down for fitting tips

Spacers:

  • Polystone™ Grade 500, high density polyethylene
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • UV Resistance: Poor
  • Translucent
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.

Bolt positions - From the front:

  • Front (by bumper) 10mm down through
  • Rear of front wheel arch (in Cab) 10mm down through
  • Centre by door pillar (under truck) 12mm up through
  • Rear (by cross member under truck) 12mm up through


The 12mm bolts go up through into the body - there is no access to the nut on these, we supply the correct thread to fit the nut - all the 10mm bolts come down through and have a nut on the bottom

TIP: before starting get as much penetration oil into and on to the 12mm nuts and thread - we find that Plus Gas is superior to WD40 for this but WD40 is better than nothing. Do this for as long as you can - a week or so if you can. About a hour or so after the first treatment, attempt to undo the bolt by a quarter turn (don't force it) and then do it up again, after the second undo it a bit further and so on.
The nuts on the 12mm bolts are captivated but can come loose, they are totally inaccessible so that if they do come loose you would have to make a hole in the body sill to get to them

FAQs

Please check out our FAQs Here

Vehicle Specific FAQs:

Do you have any kits bigger than 2 inches for this vehicle?

We can make the lift kits up to 4 inches, however the steering linkage will have to be lengthened when fitting a kit over 2 inches high.