3 inch Body Lift Kit - Pajero/Shogun/Montero Mk1 - LWB.

  • Model:MP-1-LWB-3

$123.82

3 inch Body Lift Kit - Pajero/Shogun/Montero Mk1 - LWB.

3 inch Body Lift Kit - Pajero/Shogun/Montero Mk1 - LWB.

All the parts are contained in this kit to raise your truck's body by a nominal 3 inch

Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 3 inch kit requires extra modification to your truck. See the FAQs for a full list. However we will stress that this will not be major - further instructions can be found Here and you'll find some FAQs Here.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

Polystone™ Grade 500, high density polyethylene:
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.

FAQs

Please check out our FAQs Here

Vehicle Specific FAQs:

What is the difference between a Mk 1 or Mk 2 Pajero?
The Mk1 was built between 1982 and 1991 and has a very squarish brick like style. The Mk2 was built between 1992 and 1999 and is more rounded with a less steep angle on the windscreen. Towards the end of the 90s a face lift model was introduced - this had wide stepped wheel arches. In 2000 the face lift became the Mk3 with a monocoque construction.