2 inch Full Body Lift Kit - L200 - B40 - Double Cab.

  • Model:ML2-B4T-FBL-DC-2

$225.85

2 inch Full Body Lift Kit - L200 - B40 - Double Cab.

Available Options

2 inch Body Lift Kit - L200 - 2005 - 2015 - Double Cab.

Contained in this kit will be:

  • Body Lift kit
  • Side Bracket Relocation Plates
  • Steering Column Bracket Relocation Plate
  • Extension tube for fuel hose
  • Joining tube for bottom radiator hose
  • Hose clips
  • Extended Earth Wire
  • Tub Wing Bracket Relocation Plates
  • Transfer lever extension
  • 1 metre Vacuum hose
  • The option of adding a set of High Performance Brake Hose in the colour of your choice to enhance your braking
Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

This kit is fairly easy to fit, you will need to remove the lower part or the complete fan cowling on the radiator - our instructions can be found Here.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

Polystone™ Grade 500, high density polyethylene:
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248ºF 120ºC
  • Minimum Temperature: -148ºF -100ºC
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • Rigid

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the fitting download, remove the fan/radiator cowling (if fitted) before lifting.

The L200 B4T (AKA B40) is fitted with super select transfer boxes and will need to have the lever bent forwards to clear the rear edge of the hole in the tunnel, this may also apply to the gear lever on manual trucks as well.
This can be achieved by removing the levers and cutting a 'V' nick in the front of them as low as possible, bending them forwards into their new position and then welding up the cut to strengthen them.

The mini A bar containing the number plate on the front bumper of the Warrior is bolted to the front of the chassis legs these bolts (4 in number) have to be removed before lifting the body (we can make and supply plates to re-affix the mini A bar)
Some other models may also have struts fixed between the front bumper and chassis - again these should be removed before lifting the body.

FAQs

Please check out our instruction download

Vehicle Specific FAQs:

Can I use Pajero bumper relocation plates on my L200?

Apart from the very early models (pre 1991) the bumpers on a L200 are affixed to the body and will raise with the body.