This is 2 extra spacers with M10 bolts @ 15cm long - for a Xpajun 2" lift
Handy for if you've ordered a SWB and needed a LWB kit
These are sold in pairs
Spacers:
- Polystone™ Grade 500, high density polyethylene
- Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
- Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
- Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
- Maximum Temperature: 248°F 120°C
- Minimum Temperature: -148°F -100°C
- Melting Point: 266°F 130°C
- Tensile Strength: 4550 psi (31.37 N/mm2)
- Hardness: SD65
- UV Resistance: Poor
- Translucent
- Rigid
- Specific Gravity: 0.95
Bolts & Nuts
8.8 high tensile steel bolts
NyLoc nuts
Torque settings
All Bolts 56Nm
Fitting
Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting, all the existing bolts are fitted down through - you may have to replace some up through.
