2 inch Body Lift - Trooper/Bighorn/Monterey/Jackaroo LWB

Spacers:

• Polystone™ Grade 500, high density polyethylene
• Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
• Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
• Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
• Maximum Temperature: 248°F 120°C
• Minimum Temperature: -148°F -100°C
• Melting Point: 266°F 130°C
• Tensile Strength: 4550 psi (31.37 N/mm2)
• Hardness: SD65
• Rigid
• Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting, the existing front 6 bolts are fitted down through, the rear ones are fitted up through into captivated nuts (we supply the correct bolt for the captivated nuts) - you may have to replace some of the front 6 up through.
Bumpers are raised by drilling new holes in the bumper brackets 2 inches below the original top one and (on the front only) drilling a hole 2 inches above the original lower hole in the chassis (you will need a new nut for this hole.
You may need to remove some plastic from the underside of the central console behind the gear lever and transfer lever to allow the lever to stay in gear.