3 inch Body Lift Kit - Range Rover P38 Automatic.

  • Model:LR-P38-A-3

229.63€

3 inch Body Lift Kit - Range Rover P38 Automatic.

Available Options

3 inch Body Lift Kit - Range Rover P38 Automatic.

This is a full kit for the P38 it includes the following: <

  • Lifting spacers and bolts
  • Relocation plates for front brake line brackets
  • Relocation plates for rear brake line brackets
  • Spacers and bolts for the prop shaft guard
  • Steering linkage spacer and bolts
  • Auto gear selector cable extension
  • For EAS only extension tubes and fittings


Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

This 3 inch kit is easy to fit needing no modification that is not included, except for the bumpers see FAQs - link to our P38 .pdf fitting instructions.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

Polystone™ Grade 500, high density polyethylene:
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts

Torque settings

All Bolts 50Nm

Front and Rear Brake Line Brackets Relocation Plates

Steel plate with welded nuts, supplied with high tensile bolts plus flat and spring washers

Fitting

Full fitting instructions - link to our P38 .pdf fitting instructions



FAQs

Please check out our FAQs Here

Vehicle Specific FAQs:

Do you sell/make Bumper Relocation Plates for the P38

There are problems with lifting both bumpers on the P38:
On the rear the bumper is wrapped under the cross member and very often has a trailer lighting socket attached to it, so it would need major modification to be able to lift it.
There is a air conditioning pipe that runs behind the front bumper, to be able to lift the bumper this pipe would have to be moved.

Have a chat with us if you do want to move the bumpers, we can make the relocation plates if you're happy to do the extra modifications.