4 inch Mega Body Lift Kit - Discovery 2.

  • Model:LR-Dy-2-M-4

$628.32 $565.49

Available Options

4 inch Mega Body Lift Kit - Discovery 2.

This kit contains the spacers and bolts to raise your truck's body by a nominal 4 inch and includes the following:

  • Standard Disco 4" lift kit
  • Radiator support pins
  • Bumper Relocation plates (all, rear only or none at all
  • Set of 6 extended brake hoses (2 front, 2 inner wheel arch, 2 rear) or options for 4 front and 1 rear or none at all
  • Option to add automatic gear cable extension


Options are available above to choose the number of brake hoses you require and their length (standard length included will be +4") You can specify up to +8" at no extra charge, or none if you wish (this option will reduce the price you pay).
There is also an option to add a extension for an automatic gear cable if required
Raising your body will enable you to fit bigger diameter tyres allowing you more clearance under the vehicle.

The 4 inch kit may require extra modification to your truck. See the FAQs for a full list. However we will stress that most of this will not be major - further instructions can be found Here and you'll find some FAQs Here.

We are also quite happy to answer questions on the phone, our phone number is +44 (0) 20 3598 2107 (sorry english only)

Spacers:

Polystone™ Grade 500, high density polyethylene:
  • Excellent resistance (no attack) to dilute and concentrated Acids, Alcohols and Bases.
  • Good resistance (minor attack) to Aldehydes, Esters, Aliphatic and Aromatic Hydrocarbons, Ketones and Mineral and Vegetable Oils.
  • Limited resistance (moderate attack and suitable for short term use only) to Halogenated Hydrocarbons and Oxidizing Agents.
  • Maximum Temperature: 248°F 120°C
  • Minimum Temperature: -148°F -100°C
  • Melting Point: 266°F 130°C
  • Tensile Strength: 4550 psi (31.37 N/mm2)
  • Hardness: SD65
  • Rigid
  • Specific Gravity: 0.95

Bolts & Nuts

8.8 high tensile steel bolts
NyLoc nuts

Torque settings

All Bolts 50Nm

Radiator Support Pins

Aluminium

Seat belt Tie Rods

Steel/studding - welded construction

Fitting

Refer to the general fitting page, remove the fan/radiator cowling (if fitted) before lifting.

You will need extended brake hoses to fit this kit (see our brake hoses)

FAQs

Please check out our FAQs Here

Vehicle Specific FAQs: